FREE TRP-TESTING · LIVE ON LOCATION
Free
TOTAL RADIATED POWER (TRP) testing
Bring your IoT, wearable, or wireless device to the waveLAB Ruhr/Radientum booth at The Things Conference 2026. In about 10 minutes, our RF engineers measure its Total Radiated Power (TRP) in a live anechoic chamber — a fast, honest reality check before certification or volume production.
LIVE MEASUREMENT CHAMBER · BOOTH S44
~10 min
Measurement duration per device
≤ 15×15×15 cm
Max. device size
CW · Non-Signalling
Required transmission mode
HOW IT WORKS
A real test
for your actual device
Most teams don’t find out how their antenna actually performs until certification – or worse, until units are in the field underperforming on range and battery. At TTC 2026 you can find out on the spot if your device is about 15x15x15cm or smaller.
02
We measure
Our RF engineers measure the total radiated power (TRP) live in the chamber.
03
Discuss the result
We go through the measured value with you—in concrete and understandable terms.
The entire process takes about 10 minutes.
A SMALL CATCH
We can only measure a device
that is ready to transmit.
A TRP measurement needs your device configured for a non-signalling CW transmission. The measurement itself is quick, but getting your device into that state takes a little planning. Show up unprepared and those 10 minutes turn into troubleshooting. Show up ready and you walk away with a number you can act on.
REQUIREMENTS
What your device needs for
the measurement
01 / DEVICE
Device & modem maturity
The device boots successfully, runs without crashing or rebooting, and its modem software accepts direct test commands and responds reliably.
02 / TRANSMISSION MODE
Transmission configuration
The device can be commanded to emit a maximum-power CW signal at your target frequency, with a documented method to switch it into that transmit mode (e.g. a pre-programmed button mode or serial command).
03 / BATTERY
Battery endurance
The device can sustain at least 15 minutes of maximum-power CW transmission.
04 / SIZE
Device size
The Things Conference 2026 measurement is limited to device about 15 x 15 x 15cm or below in size.
TAKES PLACE LIVE ON SITE
The Things Conference 2026 · Booth S44 · together with Radientum
READY FOR YOUR MEASUREMENT?
Register your device
now for booth S44
Registration takes two minutes. Afterward, we will send you a preparation checklist—so that your 10 minutes at the booth are truly sufficient for the measurement.
01 Fill out the form on the Radientum website
02 Receive the checklist via email
03 Come by booth S44 fully prepared
Our location
Our office
Essen
T +49 2054 8750 200
M +49 1515 8750 200
kontakt@wavelab.ruhr
Im Teelbruch 134b
45219 Essen